31
CHARGING THE BATTERIES
1. Turn off the scooter with the key and pull it out of the ignition.
2. Then open the cover securing the charging socket.
3. Insert the charger plug into the charging socket on the scooter.
4. Plug the charger’s power plug into a power outlet. The charger will start charging
and the LED lights up (red), which means it is working.
During charging, riding a scooter is not possible – immobilize function is on.
5. When charging is complete, the LED will turn green indicating the charging
is complete.
The charging time is approx. 6-8 hours.
6. After charging is complete, disconnect the charger from the power outlet
immediately.
7. Turn off the charger plug from the charging socket on the scooter.
The scooter is ready for use again.
To Next Page
Loading...
