Do not leave the device unattended when it is switched on.
Switch off the device after use. Let it cool down sufficiently before storing.
Always use the cutter on a heatproof and uncluttered table.
Only use the supplied cutting wire or a suited replacement wire.
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on www.velleman.eu.
Keep this device away from dust and extreme temperatures.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
Familiarise yourself with the functions of the device before actually using it.
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to the
device is not covered by the warranty.
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorized way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
Due to constant product improvements, the actual product appearance might differ from the shown images.
Product images are for illustrative purposes only.
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
The appliance is only to be used with the power supply unit provided with the appliance.
Keep this manual for future reference.
4. Overview
1. tip-handle connection
2. on-off switch
3. power adapter
4. cutting accessories
5. stand
6. hot wire tip
5. Operation
The appliance is only to be used with the power supply unit provided with the appliance.
Draw the design on the piece of foam, either freehandedly or using a pattern.
Choose one of the included tips and insert it into the handle. Ensure it is well-secured into the handle.
Connect the plug coming from the handle to the adapter. Insert the adapter into the mains socket.
Switch on the foam cutter and place it onto the stand. Wait for the cutter to warm up.
Hold the cutter in a comfortable position. Always try on a test object before starting on your project. Remove
large unwanted chunks first for easier handling.
We recommend using the wire tip for more detailed work. Do not use force to cut the foam and let the heat do
the work.
After cutting, switch off and disconnect the foam cutter from the mains. Let it cool down on the stand before
storing.
6. Cleaning and Maintenance
Cleaning and user maintenance shall not be made by children without supervision.
The external flexible cable of the adapter cannot be replaced, if the cord of this adapter is damaged, it is
necessary to dispose of the adapter and replace by an adapter of the same model (model HS18-0501500EU).
The foam cutter does not need any particular maintenance. However, occasionally wipe it with a damp cloth to
keep it looking new.
Do not use harsh chemicals, cleaning solvents or strong detergents.
7. Specifications
To Next Page
Loading...