ONE-TIME POWERPOD SETUP
To setup PowerPod you’ll do four things:
1) Attach PowerPod to your bike
2) Pair PowerPod to your ANT+ speed sensor
3) Pair PowerPod to your bike computer
4) Ride your bike for 5 minutes, after which power will be displayed on
your bike computer
1. Attach the PowerPod to your bike
1) Following the pictorial instructions enclosed separately, attach the
PowerPod mount to your bike. Make sure the mount is securely
attached so that the mount cannot rotate on your bike’s handlebars.
2) After attaching the mount to your bike, attach the PowerPod sensor to
to the mount, making sure the PowerPod is securely fastened so that it
cannot rotate.
2. Pair PowerPod to your ANT+ bike speed sensor
Click the button to turn on the PowerPod status light, which indicates the
operational status of your PowerPod. After 8 seconds the status light turns
off automatically. Click the button at any time to turn the light back on.
If your PowerPod is new and has not yet been paired to any speed sensor,
the status light will show SOLID RED (red light does not flash on and off).
To pair your ANT+ speed sensor to your PowerPod:
1) Wake up your ANT+ speed sensor by spinning the bike wheel where
the speed sensor is located.
2) Click PowerPod button. Status light will show SOLID RED.
3) Press and hold the PowerPod button for about 4 seconds. PowerPod
will enter its pairing mode, and the status light will FLASH GREEN.
4) Release the button when the status light is FLASHING GREEN
5) It should take only a few seconds for the pairing. When pairing is
successful, the status light will change to SOLID GREEN for a
few seconds, then turn off.
6) If pairing is not successful, after about 30 seconds the status light will
change to SOLID RED. Consult Troubleshooting for corrective action.