Velux INTEGRA KLR 200 - Adding a New Control Pad

English English
16 VELUX
®
VELUX
®
17
If you want to operate your VELUX INTEGRA
®
products with more than
one control pad, the contents in the control pad in use can be copied to
other control pads.
Note: If you have adjusted the standard programs or made your own
programs, these are not copied to the other control pads.
The instructions below show how to copy between two control pads of
the same type. If you have other controls, you must follow the instruc-
tions for these.
Start with control pad
B
which is
to receive a copy.
Go to the section Initial set-up and
carry out steps 1-3.
Tap "Receive copy".
Note: Do not tap
until step 5.
Carry out steps 2-4 with control
pad
A
which is to send a copy.
Tap
.
Tap "New product".
Tap "Copy control pad".
The control pad to send a
copy is called
A
.
The new control pad to
receive a copy is called
B
.
Adding products
Adding control pad
Adding products
Adding control pad
1
2
A
A
B
B
3
4
A
A