Velux KLR 200 - Rain Sensor Repositioning

Installation
Repositioning the rain sensor in case of retrofitting
4
3
1 SML
1 MML
2
2
3
VELUX INTEGRA
®
KLR 200
VELUX 115
Retrofitting a VELUX INTEGRA
®
roller shutter or awning blind
onto a VELUX INTEGRA
®
centre-pivot window
If you want to retrofit a VELUX INTEGRA
®
roller shutter or awn-
ing blind onto your VELUX INTEGRA
®
centre-pivot window, you
must reposition the rain sensor to the side channel of the roller
shutter or the awning blind.
Note: The mains or battery supply must be switched off while
repositioning the rain sensor.
1
Move the rain sensor from window side cover to roller shutter
or awning blind side channel.
Important: The surface to which the rain sensor is to be ad-
hered must be clean and dry.
2
Lead the cable under roller shutter or awning blind without
pulling it tight.
3
Lead the cable into the window as shown.