70 VELUX
A
A
Resetting and preparing for registration
The skylight and all connected electrical products can
be reset to remove the present registration and to
prepare for a new registration.
When resetting, the button located under the skylight
operator cover hole closest to the center of the sky-
light (A) is operated by carefully inserting a pointed
object.
1
To reset the skylight operator and connected electrical
products, close the sash by pressing button closest to
the center of the skylight (A).
2
When the skylight is closed, press and hold the button
closest to the center of the skylight (A) for at least
5 seconds. The skylight operator and other electrical
products connected to the skylight will run briefly
back and forth indicating that they are ready to be
registered.
Note: To make a new registration and reinstate the
connection with the remote control, please refer to
the instructions in section Initial set-up or Registering
new products.
To Next Page
Loading...
