Vemus Kilitronik miniK 10 - Password Management; Personal Mode - Opening with User Password; Changing User Password

Page 5
ATTENTION:
By default, the miniK10 is set to Locker Mode. The miniK10 can easily be set
to Personal Mode with either of the two below steps:
1. Before battery tab is removed, hold down key, pull the tab and
key the key pressed 3 seconds
2. Convert lock to Personal Mode at any time by entering in
MasterCode 1 0
PERSONAL MODE
• OPENING WITH USER PASSWORD:
1) Enter your 4-digit user password.On rst use factory default is <1-0-1-0>
2) Rotate handle within 5 seconds to opening direction and there will be a
conrmation beep.
• CHANGING USER PASSWORD:
If personal mode is selected (default), press and old password.
Press button again and enter new 4-digit user password. Press button
again and approve new password. You will get a conrmation beep and
green LED light will blink.
Locker Mode (Multiple User):
Use Master code to unlock and turn handle to open position. Lock is now
ready for next user to enter in their unique code.
Personal User Mode:
1) Use master code to reset the lock to factory defaults.
MasterCode 4 0
2) Default user code is now < 1-0-1-0 > and can be changed.
USER PASSWORD
OLD USER NEW USER
Below illustrations show
examples of lock installed for
right handed door. Lock can be
installed for left or right handed
NOTE: WHAT HAPPENS IF USER FORGETS THEIR PASSWORD?