Vemus Kilitronik miniK 10 - Programming and Configuration; Programming the miniK10

Page 7
PROGRAMMING THE miniK10
The miniK10 can be customized from factory default settings tailored to your needs.
ACCESSING THE PROGRAM MENU:
Press the button and then enter the 6-digit master password. Press the button.
The Red and Green led’s will blink alternately. Press the program and selection numbers
repeatedly.
0 1
Explanation:
0-1 Restores factory default settings:
Prog. No 1-1: Locker mode operation (Multiple user operation)
Prog. No 2-1: Audible beeps and conrmations
Prog. No 3-0: Penalty operation is not active
Prog. No 4-0: Sets user password to factory default
Prog. No 5-0: Service password is not active
Prog. No 6-1: Closing without password active
Prog. No 7-0: Warning of open door is not active
Prog. No 8-0: Resetting user password is not active
Prog. No 9-0: Blocking of the lock is not active
1
0 Personal Operation (individual operation)
1 Locker Mode Operation (multiple user)
2
0 Mute operation except for warnings
1 Audible operation- button feedback, warnings and conrmations
3
0 Penalty passive
1
Penalty active (lock blocked for 5 min. if wrong code entered 3 times)
4
0
Sets user default code to factory default (for forgotten combinations)
1 -
5
0
Service password is passive
1
Service password is active
6
0
Closing with password required is active
1
Closing without password is active (for personal usage)
7
0
Warning of door open is passive
1
Warning of door open is active (beeps 8 times every 5 sec.)
8
0
Resetting user password is passive (if service password is active)
1
Resetting user password is active (if service password is active)
9
0
Blocking of the lock is passive (if service password is active)
1
Blocking of the lock is active after using service password (if it is active)
Program Table
NOTE: To the right would change to
password being required to close lock
MASTER PASSWORD
PROG.
NO
SELECT.
NO
6 0
P
R
O
G
.
S
E
L
E
C
T
.