Ventec Life Systems V-Home - Changing V*Home Ventilation Therapy Settings

Controls and Settings
VentecLife.com 60
Ventilation Therapy Controls
V*Home stores up to three
pre-congured Ventilation therapy
Presets. These Presets can be enabled
and congured using the SETTINGS &
ALARMS button on the Ventilation screen
or Menu screen.
Changing Ventilation
Therapy Settings
To congure the Ventilation therapy
Presets:
1 Press the Therapy tab under the status bar, and then press the VENTILATION therapy
button.
2 Press the SETTINGS & ALARMS button on the right side of the screen. The Ventilation
therapy Preset conguration screen will appear. To modify any of the three Ventilation
therapy Presets, select the relevant Preset name from the tabs at the top of the
conguration screen.
NOTE: To enable a disabled Ventilation therapy Preset, press the Preset name, and then the
[Preset Name] Enable control. Press EDIT >, and then select Enabled, and press ACCEPT.
3 Scroll through the list of available Ventilation controls, and press the name of the control requiring conguration.
Press the EDIT > button on the right side of the screen.
4 Enter the new control setting using the numeric keypad, the slider bar, or the +/- buttons.
5 Press ACCEPT to activate your selection.
6 Follow the procedure above to modify additional controls. When conguration is complete, press the < EXIT tab.
NOTE: To congure V*Home alarms, scroll past the ventilation controls until you see the ALARMS banner. Alarm controls
are listed below the banner. See “Changing Alarm Settings” on page 81 for conguration instructions.
0 5 10 15 20 25 30L H
EXIT
SETTINGS
& ALARMS
Prepare patient circuit for ventilation,
select preset, and press START to begin.
AC-PRES
NIGHTDAY
VT-PS
MOBILE
SIMV-PRES
ACTIVE NOWSTARTSTART
No Alarms
PRESSURE (cmH20)
VT-PS
V
NOW ACTIVE
This preset is
providing
therapy
Press here to
EXIT this
screen
To start using a new
preset, select it and then
press START
Press here
if you need
to change a
control
SETTINGS
& ALARMS