To Next PageTo Next Page
Need help?Do you have a question about the Ventura Atlantic Series and is the answer not in the manual?
Assemble and lay out the frame in its correct position on a carpet or other protective covering.
Pull the awning through the channel. Ensure sides are level. Mount FixOn fittings.
Raise CM-centre pole, insert point through eyelet, position leg. Attach A-centre roof pole.
Mount CV/CH-corner poles and A-roof poles. Insert points through eyelets, position legs.
Mount canopy F-poles and G-poles. Push G-poles into canopy sleeves and connect to F-poles.
Unzip front/side panels. Tension poles in order: E, A, F, G. Roll down panels halfway.
Level interior gusset with ground. Peg corners, tension sides, and peg remaining canvas.
Mount additional AX-poles and tension. Mount SX-poles in regulator tabs and tension.
Assemble and lay out the frame in its correct position on a carpet or other protective covering.
Pull the awning through the channel. Ensure sides are level. Mount FixOn fittings.
Raise CM-centre pole, insert point through eyelet, position leg. Attach A-centre roof pole.
Mount CV/CH-corner poles and A-roof poles. Insert points through eyelets, position legs.
Mount canopy F-poles and G-poles. Push G-poles into canopy sleeves and connect to F-poles.
Unzip front/side panels. Tension poles in order: E, A, F, G. Roll down panels halfway.
Level interior gusset with ground. Peg corners, tension sides, and peg remaining canvas.
Mount additional AX-poles and tension. Mount SX-poles in regulator tabs and tension.
General| Brand | Ventura |
|---|---|
| Model | Atlantic Series |
| Category | Accessories |
| Language | English |
