Instruction for Fitting:
If you cannot achieve a proper fit DO NOT enter the contaminated area.
See your supervisor.
Maintenance & storage:
1. Use only original spare part. After use the mask must be checked, cleaned and
disinfected. Replace damaged parts. Valve discs must be replaced every other year at
the latest.
2. Store the respirator away from contaminated areas when not in use.
3. The mask should be protected from direct sunlight, grease and oil. The store should be
dry and cool. The components should not be more than 5 year old.
4. Storage of Mask+Filters -5O C.-+50 0C, max. 80% RH.
5. The filter respirator until use shall be stored in the sealed pack to retain its properties.
For transport such packs shall be suitably packed in outer cartons to protect from
climate hazards and mechanical shocks.
6. After use, an opened filter must be sealed tightly if it is to be reused, but it must be
replaced within 6 months at the latest.
Cleaning:
1. Remove the filters, cover & valve.
2. Clean the facepiece and components with a damp soft cloth or sponge, using lukewarm
water and mild detergent. A brush can be used for stubborn dirt.
3. Do not use solvents, hot water or bleaching agents.
To Next Page
Loading...