Calibration
All resistances are in-built using
matched fixed resistors. They are
measured using an ohmmeter, which
is of known accuracy and standards
used are traceable to UKAS. No
variable resistors e.g. potentiometers
are used. The resistances should
nonetheless be re-checked once a
year.
Limited Warranty
Vermason expressly warrants that for a period
of one (1) year from the date of purchase,
Vermason
Calibration Units for Personnel
Testers
will be free of defects in material
(parts) and workmanship (labour). Within
the warranty period, a unit will be tested,
repaired or replaced at Vermason’s option,
free of charge. Call Customer Service at
0044 (0) 1462 672005
for a Return Material
Authorisation (RMA) and for proper shipping
instructions and address. Any unit under
warranty should be shipped prepaid to the
Vermason factory. You should include a copy
of your original packing slip, invoice, or other
proof of purchase date. Warranty repairs will
take approximately two weeks.
If your unit is out of warranty, Vermason
will quote repair charges necessary to bring
your unit to factory standards. Call Customer
Service at
0044 (0) 1462 672005
for a Return
Material Authorisation (RMA) and proper
shipping instructions and address.
Warranty Exclusions
THE FOREGOING EXPRESS WARRANTY IS
MADE IN LIEU OF ALL OTHER PRODUCT
WARRANTIES, EXPRESSED AND IMPLIED,
INCLUDING MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE
WHICH ARE SPECIFICALLY DISCLAIMED.
The express warranty will not apply to defects
or damage due to accidents, neglect, misuse,
alterations, operator error, or failure to properly
maintain, clean or repair products.
Limit of liability
In no event will Vermason or any seller be
responsible or liable for any injury, loss or
damage, direct or consequential, arising
out of the use of or the inability to use the
product. Before using, users shall determine
the suitability of the product for their intended
use, and users assume all risk and liability
whatsoever in connection therewith.
Specifications
Resistance Ranges
Wrist straps: Low - 730 kegohms
Pass - 770 kegohms
Pass - 34 megohms
High - 36 megohms
Foot wear: Low - 97 kegohms
Pass - 103 kegohms
Pass - 34 megohms
High - 36 megohms
Accuracy: ±1%
Weight: approximately
0.17kg
Dimensions: 145 x 90 x 30mm
UNIT C, 4TH DIMENSION, FOURTH AVENUE, LETCHWORTH, HERTS, SG6 2TD UK
Phone: 0044 (0) 1462 672005, Fax: 0044 (0) 1462 670440 • e-mail: Service@Vermason.co.uk, Internet: Vermason.co.uk
TB-7543 Page 2 of 2
To Previous Page
Loading...