EasyManua.ls Logo

VERSE SUB Series - Important Notes; Looking After the Product; Connecting to the Mains; Connecting to a Mixer

VERSE SUB Series
54 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SUB User's Guide
THANK YOU FOR CHOSING A VERSE PRODUCT.
THIS GUIDE WILL GIVE YOU INFORMATIONS AND USEFUL TIPS FOR A CORRECT USE OF YOUR
INSIDER SYSTEM.
THE VERSE STAFF WISHES YOU GOOD WORK AND... HAVE FUN!
LOOKING AFTER THE PRODUCT
• Never apply excessive force to the structures or controls (knobs, switches).
• Do not stress the speaker in transit or during use.
• Do not place the device close to heat sources, in damp or dusty places or
close to strong magnetic fields.
• When possible, do not place the speaker close to units which generate strong
interference, such as radio and TV sets, monitors, etc.
• Never insert objects or liquids of any kind inside the device, for any reason.
• Clean using a soft brush or an air jet only; never use detergents, solvents or
alcohol.
• When disconnecting cables from sockets, always take hold of them by the
connector and not by the cable itself, and when winding take care to avoid
knots or twisting.
• Do not expose the speaker to direct sunlight.
CONNECTING TO THE MAINS
• To avoid the risk of electric shock, do not make connections with wet hands.
• Make sure that the mains voltage is the same as that indicated on the control
panel.
• Connect the speaker to a mains socket with earth contact.
CONNECTING TO A MIXER
• Always use good quality screened cables.
• Before making the connections, check that all the speakers you are about to
connect are switched off. You will avoid noisy, if not hazardous, signal peaks.
IN CASE OF MALFUNCTION
• In case of malfunction, contact only an authorised service centre.