FCC ID: K6620223X20
IC ID: 511B-20223X20
VX-120/170 O
PERATING MANUAL
22/64
Vertex Standard Co., Ltd.
TYP)]):
D: DCS Encode only
(the “DCS” icon will blink during operation)
T DCS: Encodes a CTCSS Tone and Decodes a DCS code
(the “T” icon will blink and the “DCS” icon will appear during operation)
D TSQL: Encodes a DCS code and Decodes a CTCSS Tone
(the “TSQ” icon will appear and the “DCS” icon will blink during operation)
Select the desired operating mode, from the selections shown above.
Tone Calling (1750 Hz)
If the repeaters in your country require a 1750-Hz burst tone for access (typically in Europe),
you can set the MONI key to serve as a “Tone Call” switch instead. To change the
configuration of this switch, we again use the Set Mode to help us.
1. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 27: M/T-CL.
3. Press the [F/W] key momentarily to enable adjustment of this Set Mode Item.
4. Rotate the DIAL knob to select “T-CALL” on the display.
5. Press the PTT switch to save the new setting and exit to normal operation.
To access a repeater, press and hold in the MONI key for the amount of time specified by the
repeater owner/operator. The transmitter will automatically be activated, and a 1750-Hz
audio tone will be superimposed on the carrier. Once access to the repeater has been gained,
you may release the MONI key, and use the PTT key for activating the transmitter thereafter.
Memory Mode
The VX-120/170 provides a wide variety of memory system resources. These include:
• 1000 “Standard” memory channels, numbered “000” through “999.”
• A “Home” channel, providing storage and quick recall of one prime frequency.
• 50 sets of band-edge memories, also known as “Programmable Memory Scan”
channels, labeled “L1/U1” through “L50/U50.”
• 10 Memory Banks, labeled “BANK 1” through “BANK10.” Each Memory Bank can be
assigned up to 1000 channels from the “standard” and “PMS” memory channels.
• 10 “Weather Broadcast” Channels.
Memory Storage
1. Select the desired frequency, while operating in the VFO mode. Be sure to set up any
To Next Page
Loading...
Need help?
General
