EasyManuals Logo

Vertex Standard VX-170 User Manual

Vertex Standard VX-170
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
FCC ID: K6620223X20
IC ID: 511B-20223X20
VX-120/170 O
PERATING MANUAL
26/64
Vertex Standard Co., Ltd.
4. If you wish to return to the original memory frequency, just press the [MR(SKIP)] key
momentarily. The display will revert to display of the alpha-numeric Tag (if any) that may
have originally appeared on the LCD.
5. If you wish to store a new frequency set during Memory Tuning, just press and hold in
the [F/W] key for one second, per normal memory storage procedure. The
microprocessor will automatically set itself to the next-available clear memory location,
and you then press [F/W] again to lock in the new frequency.
R.F. Says:
1) If you want to replace the original memory contents with those of the new
frequency, be sure to rotate the DIAL knob to the original memory channel number!
2) Any required CTCSS/DCS changes, or repeater offset modifications, must be done before
storing the data into the new (or original) memory channel location.
Deleting Memories
You may desire to delete the memories (except the Memory Channel “1” and Home Channel).
The procedure for deleting a channel is quite simple.
1. Press the [V/M(PRI)] key, if needed, to enter the MR mode.
2. Press and hold in the [F/W] key for one second, then rotate the DIAL knob to select the
memory channel to be “deleted.”
3. Press the [MR(SKIP)] key momentarily. The display will revert to memory channel #1.
The previously-selected memory will be deleted.
R.F. Says:
Important Notice! Once deleted, the channel data cannot be recovered!
Memory Bank Operation
The large number of memories available in the VX-120/170 could be difficult to utilize without
some means of organizing them. Fortunately, the VX-120/170 includes provision for dividing
the memories into as many as ten Memory Groups, so you can categorize the memories in a
manner convenient to you. You may enter and exit the “Memory Group” mode by a single
press of the [BAND] key, as we shall see below.
Assigning Memories to a Memory Bank
1. Recall the memory channel to be assigned to a Memory Bank.
2. Press and hold in the [VFO(PRI)] key for one second, then rotate the DIAL knob to select
the Memory Bank number you want as the Memory Bank for this channel (“BANK 1” ~
“BANK10”).
3. Press and hold in the [F/W] key for one second to copy the memory channel data into the

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vertex Standard VX-170 and is the answer not in the manual?

Vertex Standard VX-170 Specifications

General IconGeneral
BrandVertex Standard
ModelVX-170
CategoryRadio
LanguageEnglish

Related product manuals