FCC ID: K6620223X20
IC ID: 511B-20223X20
VX-120/170 O
PERATING MANUAL
47/64
Vertex Standard Co., Ltd.
To Activate the Password feature:
1. Press the [F/W] key, then press the [%(0)SET] key to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 30: PSWD.
3. Press the [F/W] key momentarily to enable adjustment of this Item.
4. Rotate the DIAL knob to set this Set Mode Item to “PWD. ON.”
5. When you have made your selection, press the PTT switch to save the new setting and
exit to normal operation.
6. If you wish to disable the Password feature, just repeat the above procedure, rotating the
DIAL knob to select “PWD.OFF” in step 4 above.
R.F.Says: If you forget the password number, you may turn on the transceiver by performing
the “All Reset” procedure (see page ??). However, the VX-120/170 will clear the password,
as well as all memories, and will restore all other settings to factory defaults.
Programming the Key Assignments
Default VX-120/170 Set Mode Items have been assigned (at the factory) to the [7(P1)] and
[8(P2)] keys. These may be changed by the user, if you wish to assign another Set Mode Item
to either or both of these keys.
To change the assignment of a key’s Set Mode Item:
1. Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.
2. Rotate the DIAL knob to select the Set Mode Item which you wish to assign to the key as
a Menu short-cut.
3. Press and hold in the [7(P1)] or [8(P2)] key for one second to assign the Set Mode Item
to the [7(P1)] or [8(P2)] key.
R.F. Says:
The following Set Mode Items may not be assigned to the [7(P1)] and [8(P2)]
keys.
Set Mode Item 11: CW WRT
Set Mode Item 17: DT WRT
Set Mode Item 31: PSWD W
Changing the Channel Steps
The VX-120/170’s synthesizer provides the option of utilizing channel steps of
5/10/12.5/15/20/25/50/100 kHz per step, as well as an automatic step selection based on the
current operating frequency (“AUTO”), any number of which may be important to your
operating requirements. The VX-120/170 is set up at the factory in the “AUTO” configuration,
which probably is satisfactory for most operation. However, if you need to change the
To Next Page
Loading...
Need help?
General
