Why is there no water coming from my Vertex Water Products Water Filtration System?
The lack of water from your Vertex Water Products Water Filtration System could be due to a few reasons. First, ensure the feed water is turned on. Second, check that the tank valve is fully open. Finally, low feed pressure (below 40 psi) can also cause this issue. If the pressure is too low, increase it or install a booster pump.
What to do if my Vertex Water Products Water Filtration System is constantly draining water?
If your Vertex Water Products Water Filtration System continuously drains water, the auto-valve or the check valve might not be closing properly. Try purging the system again by locking the clean water valve open and turning the inlet water on for thirty minutes.
General| Brand | Vertex Water Products |
|---|---|
| Model | PureWaterMachine PT-4.0 |
| Category | Water Filtration Systems |
| Language | English |
Step-by-step process for inserting the RO membrane into its protective housing unit.
Steps for drilling a hole and mounting the dedicated faucet for purified drinking water.
Guide to connecting all the necessary water lines (feed, drain, tank, faucet) using provided fittings.
Initial steps to get the system operational, including checking for leaks and flushing.
Details on replacing RO membrane and other filter elements, including part numbers and intervals.
To Next Page