Vertex™ Omega 130 / Instruction Manual © Vertex Technologies
Seized bearings or Motor-Block
Contact your dealer for Service
Warranty, Service and Conditions:
Vertex Omega Skimmers carry a two-year limited manufacturer warranty. Parts and/ or components damaged
due to misuse, improper installation or normal wear will not be covered under warranty. Vertex Aquaristik™
deserves the right to warranty products based upon inspection. If any damages occurred due to any of the
following reasons (but not limited to), it will not be covered by warranty:
Excessive Calcification
Improper assembly
Custom modifications
Using parts and components other than
supplied by vertex and/ or utilized in the
original design
Running the pump dry
Improper electrical voltage and/ or
frequency
Cutting the pump cable to use other plug
types
Procedures other than noted in this
guide.
Physical damage or what caused by
negligence
All warranty related issues should be handled at the point of purchase location by trained staff. Please contact
your dealer for warranty and/ or any other service/ maintenance the unit might require.
Pay attention to all the warnings and pointers noted in this guide and use common sense. To avoid damage to
property, livestock and/ or personal injury please follow all these instruction and/or consult with a professional.
Vertex Aquaristik™ will not be held accountable for any damages the misuse, modifications and/ or improper
installation of this unit may cause.
For additional information regarding this and/ or any other Vertex Aquaristik™ products, please either consult
with your dealer or the following resources:
Website: www.vertexaquaristik.com
E-mail: info@vertexaquaristik.com
To Previous Page
Loading...
Need help?
General