To Next PageTo Next Page
Need help?Do you have a question about the Vetus BOW3512C and is the answer not in the manual?
General| Brand | Vetus |
|---|---|
| Model | BOW3512C |
| Category | Boating Equipment |
| Language | English |
Guidelines for fitting the Vetus bow thruster and importance of precise installation for reliable performance.
Warning about swimmers/boats, passing safety instructions, and applying general safety rules.
Do not touch moving parts, hot surfaces, or flammable materials; stop before adjustments.
Disconnect battery poles, use appropriate tools, and deactivate main switch when not in use.
Instructions for fitting tailpiece and intermediate flange using packing, sealant, and checking dimensions.
Steps for final assembly: checking dimension 'A', greasing shafts, installing propeller and motor.
Warning against testing the thruster out of water unless safe distance is ensured; limit run time to 5 seconds.
Check carbon brushes for wear annually, or bi-monthly for intensive use; replace if minimum length is reached.
Troubleshooting steps for motor not operating: check switches, fuses, and power indicator LED.
Motor overheats, thermal protection trips, panel warns; LED glows red until cooled.
Causes for slow motor operation: flat battery, bad connections, worn brushes, low temperature.
Causes for no thrust: damaged propeller blades or broken drive pin due to foreign objects.
Key components in the wiring diagram: Main fuse, main switch, solenoid switch, motor, control panel, battery.
Warning against simultaneous engagement of relays (K1/K2) when using foot switches; requires extra relays.
Table detailing battery capacity (CCA and Ah) and cable cross-section for the BOW3512C model.
Specifies total cable length, cable dimension (AWG), and fuse rating (160 A) for the unit.
