Please read the instructions carefully before using this
device.
Please calibrate the device before use for most
accurate results.
Please keep the manual handy for quick reference and
troubleshooting.
Considerations
Avoid covering the air intake areas during use to avoid
inaccurate measurements.
Avoid use of solvents to clean the product as residual
fumes will skew air quality readings.
Avoid water or other liquids near the product to avoid
electrical damage.
Do not allow unauthorized modification or repair of this
product.
Precautions
Start Up
When you long-press the center power button, the air
quality monitor will boot up. Detector will proceed through
its warm-up sequence for 200 seconds to allow sensors to
preheat and fan to draw in fresh ambient air. This is
necessary for accurate results. If device is new, please
calibrate first for most accurate results. Countdown timer
showing remaining time for warm-up sequence is shown in
the HCHO display area. HCHO and TVOC will not display
level until 200 seconds preheating process is completed
Instructions
03
To Next Page
Loading...