ĚũƵƐƟŶŐ a brake ĚŝƐĐ
If a brake is very ƟŐŚt:using M5 hex wrench and scroll counterclockwise screws
of brake disc tensioner pulley,slightly shorten a length of a tail brake cable,then
ƟŐŚten a tensioner pulley.If you think that brake is very free,loosen a tension
pulley,pull a brake cable to slightly increase a length of its tail.Tighten a tension
pulley.
ĚũƵƐƟŶŐ a ŚĂŶĚůĞ bars
Staggering of steering rack: using a M5 hex wrench,ƟŐŚten two screws near the
folding mechanism.
Using a cŽŶŶĞĐƟŶŐ pipe tŽ pump ǁŚĞĞůƐ
If a rear wheel of Electric Scooter deŇĂted,connect a cŽŶŶĞĐƟŶŐ pipe to a wheel
nipple to pump it .First,remove the a cap of pin,then ƟŐŚten a ĮƚƟŶŐ,and thenyou
startto pump a wheel.
19
To Next Page
Loading...