Need help?Do you have a question about the Vibe BlackAir V12 and is the answer not in the manual?
General| Type | Subwoofer |
|---|---|
| Size | 12 inches |
| Surround Material | Foam |
| RMS Power | 400W |
| Impedance | 4 ohms |
| Voice Coil Diameter | 2.5 inch |
| Mounting Cutout Diameter | 11.125 inches |
Safety advice on amplifier load, heatsink heat, and proper installation precautions.
Details on coverage, exclusions, and procedures for the 12-month VIBE product warranty.
Contacting international dealers for country-specific warranty policies.
Critical caution regarding permanent hearing damage from high sound pressure levels.
Proper placement and ventilation advice for mounting the VIBE enclosure to prevent overheating.
Instructions for connecting power, including cable gauge, fuse placement, and battery connection.
Proper connection of the ground cable to the amplifier and chassis for optimal performance.
Explanation of the amplifier's automatic turn-on feature without a remote wire.
Advice on routing RCA cables to minimize interference and ensure signal integrity.
Connecting to source via RCA, with emphasis on cable routing to avoid interference.
Connecting using speaker wires from the headunit when low-level outputs are unavailable.
Function of the gain control for matching headunit signal to amplifier input level.
Setting the low-pass filter frequency (50-250 Hz) for bass response customization.
Adjusting bass boost (0-12dB at 45 Hz) and its impact on amplifier load.
Interpreting the white power LED and blue protection LED for operational status and faults.
Specifies the 25 Amp fuse requirement and warns against using higher ratings.
Guidance on mounting the enclosure in the luggage compartment for optimal sound and secure placement.
Step-by-step guide to setting amplifier gain for optimal performance without distortion.
Routine for blending subwoofer frequencies with car speakers for a balanced sound.
Recommended method for breaking in a new subwoofer to achieve full potential.
Steps to resolve problems with the amplifier not powering up, checking connections and fuses.
Diagnosing the protection LED, checking for shorts, overheating, or amplifier damage.
Troubleshooting steps for blown fuses, including wiring checks and correct fuse rating verification.
Simple method to fix distorted sound by adjusting the gain control.
Contact information for technical support within the UK, including phone number and business hours.
Guidance for international technical support by contacting country-specific distribution agents.
Details on model, impedance, power ratings, fuse rating, and physical dimensions of the enclosure.
Crucial safety warning about high sound pressure levels and user responsibility for hearing safety.
To Next Page
