Victor 315FC - Gas Hose and Torch Handle Connection

5-28
SET-UP AND SAFE OPERATING PROCEDURES
0056-0114
Figure 10: Opening the Cylinder Valve
5.03 GAS HOSES
Connect the oxygen hose to the oxygen regulator. Tighten the connection firmly with a 1.
wrench.
Adjust the oxygen regulator to allow 3 - 5 PSIG to pass through the hose. Allow oxygen to 2.
flow for 5 - 10 seconds to clear the hose of dust, dirt, or preservatives. Shut off the oxygen
flow.
Attach and clear the fuel hose in the same manner.3.
Important Safety Notes
Be certain cylinder valves and regulator connections are completely free of dirt, dust, oil, or •
grease.
If oil, grease, or damage is detected on the cylinder valves, • DO NOT use the cylinder. Notify
the cylinder supplier immediately.
If oil, grease, or damage is detected on the regulator, • DO NOT use the regulator. Have the
regulator cleaned or repaired by a qualified repair technician.
Never stand directly in front or behind a regulator when opening the cylinder valve. Stand so •
that the cylinder valve is between you and the regulator.
Always open the cylinder valves slowly and carefully.•
Always check for leaks on the regulator and cylinder valve connections.•
Setting Up Equipment for Welding