SECTION 2:
GENEral SafETy INfOrmaTION
Be sure to read and understand all safety and operating instructions provided before using this
apparatus. rETaIN THESE INSTrUCTIONS IN a rEaDIly aVaIlaBlE lOCaTION fOr fUTUrE
rEfErENCE.
The following preliminary safety checklist is the basis for further specific safety information noted
throughout this booklet.
WARNING
This product contains chemicals, including lead, or otherwise produces chemicals
known to the State of California to cause cancer, birth defects and other reproductive
harm. Wash hands after handling. (California Health & Safety Code § 25249.5 et seq.)
WARNING
DO NOT attempt to use this apparatus unless you are trained in its proper use or are under
competent supervision. For your safety, practice the safety and operating procedures
described in this guide every time you use the apparatus. Deviating from these procedures
may result in fire, explosion, property damage and/or operator injury.
If, at any time, the apparatus you are using does not perform in the usual manner, or
you have difficulty in the use of the apparatus, shut the system off and STOP using it
immediately. DO NOT use the apparatus until the problem has been corrected.
WARNING
Service or repair of apparatus should be performed by a qualified repair technician only.
Improper service, repair, or modification of the product could result in damage to the
product or injury to the operator.
NOTE
The term “Qualified Repair Technician” refers to repair personnel capable of servicing
apparatus in strict accordance with all applicable Victor “Parts & Service Bulletins” and
literature.
2.01 HOUSEkEEpING
The work area must have a fireproof floor.1.
Work benches or tables used during welding, cutting, and heating operations must have 2.
fireproof tops.
Use heat resistant shields or other approved material to protect nearby surfaces from sparks 3.
and hot metal.
General Safety Information
To Next Page
Loading...