Victory ROSE - Operation of Other SPA Devices

Proceedtorinsingandplacingthesandbed. Torinseandplacethesandbedmovethesix-
functionvalvecontrollevertoposition(3).Next,turnonthefilteringpumpforabout15seconds.
Whileperformingtheactivitymonitorthegauge'sglass(f)ofthesix-functionvalve.Whenwater
flowingthroughthegauge'sglassiscleantheprocessofrinsingandplacingthesandbedought
tobestoppedbymanuallyturningoffthefilteringpump.
Theprocessofrinsingandplacingthesandbedisfollowedbyfillingupthewhirlpoolbathand
thestillingbasinwithwateruptothelevelthatenablestoconnecttheappliances.
Whenfillingupthebathandthestillingbasinwithwateriscompleted,turnonthefilteringpump
andcarefullydeaeratethechamberofthefilter. Todosoturnonthedeaerationvalve(d)
installedinthefilter'slid. Theairwillnowbepushedoutofthefilterchamber.
6.Operationofotherdevicesofthebathtub.
Settingofthesensorofthewaterlevel.
Wefillthebathtubuntilthemomentwhenthewaterlevelreachestheleveloftheinstalled
sensor.Withthescrewdriverweunscrewveryslowlyaspresentedinthepictureuntilthediode
lightsup.Lightningofthediodeconfirmspropersettingofthesensor. Thenwatershallbe
disposedfromthebathtub.Whenthewaterlevelislowerthanthelevelofinstalledsensorthe
diodeswitchesoff.
Diode
Tapscrew
Settingthesensoronthewaterlevel
Exchangingbatteriesforremotecontrol
BatteryCr2032
RemotecontrolisequippedwithCR20323Vbattery.Inorder
toexchangethebatteryyoushould:
Removetheholeplugfromthebackpartoftheremote
control
Unscrewscrewsconnectingthebodyoftheremote
control(seethepicture)
Exchangethebattery
Putbothpartsofthebodyoftheremotecontrol
togetherandscrewthescrews
Placetheholeplugsinthebackpartoftheremote
control
1.
2.
3.
4.
5.
Remark!Checkwhetherthegasketisproperlyplacedso
thattheremotecontroliswaterproof.