16.6.6. Relays triggered by Inverter High temperature
• Start on high temperature warning: Toggle this feature on or off.
• Start when warning is active for: Set a delay to avoid temperature rises which are temporary, caused by brief high AC
demands.
• When warning is cleared stop after: Set a delay to ensure that a reduction in inverter temperature - usually caused by lower
power demand - is stable.
16.6.7. Relays triggered by Inverter overload
• Start on overload warning: Toggle this feature on or off.
• Start when warning is active for: Set a delay to ensure that the inverter overload warning has not been triggered by a
high-demand of AC power of only short duration.
• When warning is cleared stop after: Set a delay to ensure that the reduction in AC power demand is stable.
16.6.8. Automatic periodic 'Test run'
This feature allows automatic generator starts, periodically, as a 'test run'.
• Test run interval: Set the interval between test runs.
• Skip test run if has been running for: The test will be skipped if during the test run interval the generator ran for at least as
long as it would on a 'test run'.
• Test interval start date: The 'test run' interval counter will start from the date entered here. No test runs will be carried out until
the date set here has been reached.
• Start time: Time of day at which the generator 'test run' will commence.
• Test duration: Duration of the test.
• Run until battery is fully charged: Enabling this feature will cause the 'test run' to continue until the battery is fully charged -
instead of for a fixed amount of time.
16.6.9. Manual Start Feature
Use the Manual start feature to remotely start the generator. You can also press Start when the generator is already running -
doing so will ensure that the generator won't automatically stop when the condition which caused it to start has been satisfied. In
other words, the Manual start feature will override the autostop parameters.
There are two ways to start the generator manually:
1. Using the Manual start menu: Go to Generator start/stop → Manual start; and then toggle the graphic to start the generator.
Color Control GX Manual
Page 104 GX - Generator auto start/stop
To Next Page
Loading...
