If you have multiple sensors, you may wish to physically write this device ID on the sensor case itself to help keep track.
The sensor should now be visible in the main menu - by default it is labelled 'Generic temperature sensor (##)'
It is possible inside the temperature sensor menu to adjust the type, and also to set a custom name.
The Ruuvi sensors are estimated to last more than 12 months on a single replaceable CR2477 3V Li coin battery. Both the
internal battery voltage and the battery status are displayed in the menu of the respective sensor. Status 'Ok' = battery voltage
≤2.50V. Status 'Sensor battery low' = battery voltage ≥2.50V.
It is possible to update the firmware for the Ruuvi with Ruuvi's own separate phone app, though this is not necessary unless you
are experiencing issues.
Color Control GX Manual
Page 24
Connecting supported non-Victron
products
To Next Page
Loading...
