11.4.5. Shared Current Sense (SCS)
This feature forwards the battery current, as measured by a battery monitor connected to the GX device, to all connected solar
chargers.
The solar chargers can be configured to use the battery current for its tail current mechanism that ends absorption when the
current is below the configured threshold. For more information about that, refer to solar charger documentation.
This feature only applies to systems that are not ESS and/or don’t have a managed battery, since in both of those cases the
MPPT is already externally controlled.
Requires MPPT solar charger firmware v1.47 or newer.
11.4.6. Controlling BMS
For systems with multiple BMSs connected, this allows selection of which BMS to use for DVCC. This also allows the use of a
BMV or SmartShunt for SoC tracking by selecting a BMV as battery monitor (Settings → System setup) while the BMS is still
used for DVCC.
This setting is available in the Settings → DVCC menu on the GX device.
Color Control GX Manual
Page 63
DVCC - Distributed Voltage and Current
Control
To Next Page
Loading...
