2. All tank senders as mentioned in the chapter Connecting Victron products [8] and Connecting supported non-Victron
products [13] are supported.
Configuration step-by-step
Before proceeding with the following steps, you must connect the GX device to the NMEA 2000 network to which the MFD is
connected. Use our VE.Can to NMEA 2000 micro-C male cable to connect the GX device to the NMEA 2000 network and ensure
NMEA2000-out of the VE.Can port is enabled in the GX device.
The procedure below does not replace the Garmin manual; Be sure to read the Garmin documentation that accompanies your
MFD; There are some differences in the menu navigation of the various MFDs.
1. Connect the tank sensors to your GX device.
2. Make sure the tank sensors are set to a fluid type supported by your MFD.
This is done in the setup menu of the tank sensor in the Remote Console - Device List → [your_tank_sensor] → Setup →
Fluid type
3. On your Garmin MFD, go to Settings > Communications > NMEA 2000 Setup > Device List and verify that all tank sensors
are listed.
4. Configure the tank level sensors by opening a gauges screen and then select Menu > Tank Preset where you can select a
tank level sensor to configure, change the name, type, style, capacity and position of the tank.
14.6. Configuration of multiple tank level measurements via NMEA2000-out for
Navico MFDs
Modern Navico MFDs such as the Simrad NSO EVO3 series are capable of displaying different types of tank levels.
The following restrictions apply:
Color Control GX Manual
Page 90 Marine MFD integration by NMEA 2000
To Next Page
Loading...
