6. Release button E and follow onscreen instructions.
This is the text shown during programming:
========== Start Programming from … ==========
.................
========== Finished ==========
Please remove … and wait for reset
Note: in case the screen stays solid blue (no Victron logo) after the reboot, there are three things that could be
wrong:
1) There is still a BMV or other VE.Direct product connected to VE.Direct port 1, disconnect it before the
reboot.
2) There is a problem with finding the new firmware on the microSD or USB. Double check its contents and
formatting format (FAT or FAT32). NTFS disk format is not supported.
3) The USB-stick hardware is not supported, try your luck with another stick or use a SD-card
To Previous Page
Loading...
