Videocon DDB DLX - Page 44

44
1
After SW loading is complete i.e. 100%,
the set will go to stand by automatically
and will restart again.
2
The set is in M
-Node now. Then go to
Design Menu by Pressing MENU =>
AUDIO MENU => 8 5 3 2
3
Go to Setup design menu and Select Clear
EEPROM option and press OK key of
remote.
4
After Clear EEPROM, the set will go to
stand by and will again restart
automatically in RF source.
5
Then verify the modelwise Audio/ Video
settings as per Design data. Verify the SW
date and version in Version info menu of
Design data
6
Then press Shipping in Setup design menu
by pressing OK key of remote, then Switch
OFF and again Switch ON the SET. The SW
loading process Is complete.