CAUTION
Risk of explosion if the battery is replaced by an incorrect type
Wait one-half hour after switching off before handling parts
- Replacement of a battery with an incorrect type that can be defeat a safeguard;
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of
a battery, that can result in an explosion;
- Leaving a battery in an extremely high temperature surrounding environment that
can result in an explosion or the leakage of flammable liquid or gas;
- A battery subjected to extremely low air pressure that may result in an explosion or
the leakage of flammable liquid or gas.
NMP599-W
Quick Start Guide
This printed quick guide provides a quick walk-through of the set-up process.
For complete documentation, please visit https://www.viewsonic.com/us/support.
3
back of the monitor.
4 Secure the media player to the monitor.
5 Connect the HDMI cable and AC adapter.
Port Connections
Adapter Cable
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure and Industry Canada RSS-
102 RF exposure limits set forth for an uncontrolled environment. This device and its
antenna must not be co-located or operating in conjunction with any other antenna or
transmitter. To comply with FCC RF exposure and Industry Canada RSS-102 RF
exposure compliance requirements, this grant is applicable to only Mobile Configura-
tions. The antennas used for this transmitter must be installed to provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
Box Content
NMP599-W Device Power adapter Wi-Fi antenna HDMI cable
Velcro (2 sets) Power bracket and Device quick Software quick
micro SD card bracket guide guide
screw*2
2
1 12
11
10
9 Power LED
10 USB port
11 Reset
12 Mounting hole (screw spec: M4)
Cet equipement est conforme aux limites d’exposition aux rayonnements enoncees
pour un environnement non controle et respecte les regles d’exposition aux
frequences radioe lectriques (RF) CNR-102 de I’IC. Cet equipement doit etre installe et
utilize en gardant une distance de 20 cm ou plus entre le radiateur et le corps humain
(a I’exception des extremites : mains, poignets, pieds et chevilles).
Mounting and Installation (USB mouse required)
1 Attach the wireless antenna by screwing the antenna clockwise onto the post.
2 Mount the media player to the back of the monitor using the velcro.
1 Separate the Velcro stripe into singles.
2
surface of the media player.
System Setup
1 Boot up
Plug in the AC adapter to the media player and it
will power on automatically.
Once the user has exited the boot up screen,
users can go through system configurations in
both landscape and portrait orientations.
NMP599-W_QSG_ENG_Rev.1a_01-25-21
To Next Page
Need help?
General
