Wired connection
To use the wired Ethernet connection, first connect an Ethernet cable then
disable the Wireless LAN interface.
1. Click the Wireless LAN setting, the wireless configuration UI will be
launched. (Fig. 2.3.1)
2. Click the ON/OFF button as indicated below to turn the Wireless interface
off. (Fig. 2.3.2)
DHCP – automatically assign network IP address
3. Turn on the Ethernet interface. For DHCP environments, configuration
will be finished in this step.
(Fig. 2.3.5)
Static IP – manually assign network IP address
4. Click Modify Network to make a static IP configuration.
(Fig. 2.3.6)
To Next Page
Loading...
