- 20 –
ViewSonic Corporation
Confidential - Do Not Cop VP950b
SST25LF020A/040A devices significantly improve performance, while lowering
power consumption. The total energy consumed is a function of the applied volt-
age, current, and time of application. The SST25LF020A/040A devices operate
with a single 3.0-3.6V power supply. The SST25LF020A devices are offered in
an 8-lead SOIC 150 mil body width (SA) package.
Pin Diagram:
PIN Descriptions:
Symbol Pin Name Functions
SCK Serial Clock
To provide the timing of the serial interface.
Commands, addresses, or input data are latched on the rising
edge of the clock input, while output data is shifted out on the
falling edge of the clock input.
SI
Serial Data
Input
To transfer commands, addresses, or data serially into the device.
Inputs are latched on the rising edge of the serial clock.
SO
Serial Data
Output
To transfer data serially out of the device.
Data is shifted out on the falling edge of the serial clock.
CE# Chip Enable
The device is enabled by a high to low transition on CE#. CE#
must remain low for the duration of any command sequence.
WP# Write Protect
The Write Protect (WP#) pin is used to enable/disable BPL bit in
the status register.
HOLD# Hold
To temporarily stop serial communication with SPI flash memory
without resetting the device.
VDD
Power
Supply
To provide power supply(3.0-3.6V)
VSS Ground
To Next Page
Loading...
