ViewSonic VP950B - Page 44

- 44 –
ViewSonic Corporation
Confidential - Do Not Cop VP950b
5.8 HDCP Upgrade Procedure
1 Equipment Needed
- Monitor( TSUM Series )
- Fixture for Firmware Upgrade
- Power Adapter (P/N: 47.58201.001) *1 for Fixture
- VGA Cable (P/N: 42.59901.003) *1(Pin 4, 11 should be connected to GND)
- PC (Personal Computer)
- LPT Cable (P/N: 42.59906.001) *1
- HDCP Upgrade code
- One additional monitor for checking the program execution
2 Setup Procedure
3.2.1 Connect PC to the additional monitor.
3.2.2 Connect Power Cord to Monitor(TSUM series).
3.2.3 Connect P3 of Fixture with Monitor(TSUM series) by VGA Cable.
3.2.4 Connect P4 to the Signal Generator (eg.Chroma2326) for verifying it after the
operation being completed.
3.2.5 Connect P2 of Fixture with printer port of PC by LPT Cable.
3.2.6 Plug Power Adapter to Fixture.
3.2.7 Open DDC/CI