3. Connect the tool with air hose of compressor and check air
supply is at least 60 PSI. The gun is now ready to use. Press the
head of the gun onto the work piece to be fastened, and squeeze the
trigger to fire nail or staple.
Maintenance:
● Lubricate gun by applying 2-3 drops of air tool oil to the air intake
daily.
● Keep the gun clean.
● Remove top plate covering striking pin and clean monthly or after
every 50 hours use.
● Use a water separator in compressor line to reduce moisture
contamination and possible corrosive damage to tool.
DECLARATION:
To Next Page
Loading...