Viking Electronics E-30-IP Quick Start Guide

QUICK START GUIDE
VIKING Electronics, Inc.
K See Product Manual for complete installation and programming instructions.
1.0 Out-of-Box
1.1 Verify that you have received all of the parts listed
1.2 Download the product manual
1. Go to www.vikingelectronics.com and
enter E-30-IP in the search box
2. Click E-30-IP in the search results
3. Click Product Manual to open and
download the PDF
1.3 Download and install the programming software
1. Go to www.vikingelectronics.com and enter E-30-IP in the search box
2. Click E-30-IP in the search results
3. Scroll down the page to Downloads, click IP Programming Software
4. Install the programming software by saving or opening the file and then clicking on
setup Viking IP Programming.exe
5. Follow the prompts on your screen to complete software installation
2.0 Power Source
Select PoE Switch or PoE Injector that meets the following requirements:
1. IEEE 802.3af / 802.3at / 802.3bt compliant
2. Capable of providing at least 4 Watts (class 1)
Note: CAT5e (or higher) cable recommended
X 1
E-30-IP or E-30-IP-EWP
Entry Phone
X 1
Torx T-10 Security Bit
X 5
Gel-Filled Butt Connectors
X 1
Faceplate Gasket
X 4
6-32 x 3/4” Flat Head Torx
Drive Screws
X 1
Flush Mount Back Box
X 1
Wire Nut
Scan the QR code to
open and download
the product manual
- OR -
E-30-IP or
E-30-IP-EWP
VoIP Entry Phone
September 17, 2019

Viking Electronics E-30-IP Specifications

General

Humidity	5% to 95% non-condensing
Network Interface	10/100 Mbps Ethernet
Talk Time	Programmable
Ingress Protection	IP66
Audio	Full Duplex
Power over Ethernet	Yes (802.3af)
Operating Voltage	48V DC
Speaker	8 Ohm
Microphone	Electret Condenser
Ports	RJ45
Audio Codec	G.711
Compliance	FCC, CE