Villager ET 555 - User Manual

Questions and Answers

J
Jacob AlexanderAug 6, 2025
What to do if my Villager ET 555 Trimmer line won't advance after restarting?
- J
  Jose PhillipsAug 7, 2025
  If the line on your Villager Trimmer isn't advancing, there could be several reasons. First, the line might be welded to itself; try lubricating it with a silicone spray. Second, the spool may not have enough line; in that case, install more line. Third, the line could be too short; try pulling the lines while pressing and releasing the bump button. Finally, the line might be tangled on the spool; remove it and rewind it.
D
Dr. Gina CoxAug 14, 2025
Why does grass wrap around the attachment shaft and trimmer head assembly of my Villager ET 555 Trimmer?
- E
  Elizabeth PrestonAug 14, 2025
  Grass wrapping around the attachment shaft and trimmer head assembly of your Villager Trimmer is often caused by cutting tall grass at ground level. To resolve this, cut tall grass from the top down.
R
Rodney StoneAug 21, 2025
What to do if cutting head is hard to turn on my Villager ET 555?
- M
  Melody FlemingAug 21, 2025
  If the cutting head on your Villager Trimmer is hard to turn, it is likely due to grass wrapped around or built up around the head. Cleaning the affected parts of the machine should resolve this issue.
T
tracy56Aug 29, 2025
What to do if my Villager Trimmer stops and will not start again?
- E
  Eduardo WrightAug 30, 2025
  If your Villager Trimmer stops and won't start again, first check the plug. If the plug is not the problem, contact a dealer to check for damage.