8504026
2
4-FUNCTION RADIO REMOTE CONTROL SETTING MANUAL
FUNCTIONS:
• 4 functions: “A”, “B”, “C” and “D”;
• “A” and “B” are set at maximum reception sensitivity;
• “A” and “B” have programmable sensitivity.
• Programmable delay for “C” and “D” (DIP1): 0.5 or 1 second.
TRANSMITTER power supply: 7.2V 1600 mAh batteries
CODE programming (dip-switches “D1”)
Use switches 1 to 14 to set the SAME CODE on all the transmitters and receivers installed in a
system.
SENSITIVITY Programming
Take the transmitter to the desired distance for performance of functions "C" and "D".
1. Set DIP1=DIP2=OFF.
2. Press the "MEMO" key and keep it pressed for 4 seconds:
• the buzzer and the "LGC" LED are triggered in slow on-off mode;
• the green READY light goes out.
3. Press function key "C" key and keep it pressed for at least 10 seconds:
• During reception, the red "LGC" red flashes quickly;
• the buzzer sounds in even slower on-off mode.
4. If the programming has been successful the buzzer emits a 4 second beep, the green
"READY" LED comes on and the red "LGC" LED goes out.
If the programming is not successful, the red “LGC” LED remains constantly on. Exit the
programming mode by pressing the "MEMO" key briefly, and repeat the procedure from
point 2.
If the programming operation is interrupted by the operator, the red “LGC” LED
continues to flash, and the buzzer continues to sound in on-off mode: to return to normal
mode, press the "MEMO" key.
5. Check that when function keys “C” and “D” are pressed from the position required, the
receiver switches on properly, without interruptions.
If interruptions occur, set DIP1=ON, which sets the delay after release to 1 second.
WARNING!!! This means that when the control is released, the movement will still
continue for one second.
6. Check that functions “C” and “D” do not respond beyond the chosen distance; otherwise,
program a shorter distance.
7. To increase the programmed distance, set DIP2 in "D2" on ON.
Whenever the status of dip-switch "D2" is changed, the green LED gives two flashes to indicate
dip-switch self-diagnosis.
• If the green LED continues to flash when the receiver is switched on, a distance of about 3
metres for activation of functions C and D is set. (Memory failure fault).
• If the green LED flashes continuously, send the receiver for repair.
To Next Page
Loading...
