VINCENT Inspired Medical VHB15A User Manual (English)

Questions and Answers:

K
Kayla JonesAug 4, 2025
What to do if patient-side temperature data flashes red on my VINCENT Inspired Medical VHB15A Humidifier?
- W
  William BurnsAug 4, 2025
  If the patient-side temperature data display on the LCD flashes red, it indicates that the patient-side temperature is either above the high-temperature alarm limit (invasive 41°C, non-invasive 38°C) or below the low-temperature alarm (invasive 34°C, non-invasive 29°C). If the temperature is too high: * Turn the power off. * Wait for the temperature to decrease. * Turn the power back on. If the red flashing continues, disconnect and use a new unit. If the temperature is too low: * Press the silence alarm to extend the heating time. * Verify that the ambient temperature is not below the operating range. * Check if the air conditioning is making the room too cold.
S
stevenfuentesAug 9, 2025
What to do if the chamber outlet temperature data displayed on the LCD of VINCENT Humidifier is lower than 29°C and flashes in red?
- X
  xrodriguezAug 9, 2025
  If the chamber outlet temperature is less than 29°C and flashing red (only in invasive mode), you should: 1. Check whether the temperature probe is installed correctly. 2. Check if the chamber has water.
D
Denise PowersAug 14, 2025
What does it mean when chamber symbol is flashing on VINCENT Humidifier?
- B
  Barry SharpAug 14, 2025
  When the chamber symbol is flashing, it indicates a malfunction of the heater plate sensor. In this case, contact maintenance or your local supplier.
J
Jared BaxterAug 18, 2025
Why is humidity less than 80% (Invasive) or 70% (Non-invasive) after startup for 20 minutes on VINCENT Inspired Medical VHB15A?
- W
  William Wood DVMAug 19, 2025
  This may be due to: 1. Flow or room temperature exceeding the allowable range. 2. Data cable failure. 3. The chamber running out of water.
R
Rebecca LewisAug 25, 2025
What to do if the chamber outlet temperature displays “--” and flashes red on VINCENT Inspired Medical VHB15A?
- M
  Mark MarquezAug 25, 2025
  If the chamber outlet temperature data displays as “--” and flashes in red, it indicates a malfunction of the chamber outlet probe. Replace the data cable to resolve this issue.
B
Brenda AndersonAug 29, 2025
How to fix patient-side temperature displaying as “--” and flashing red on VINCENT Inspired Medical VHB15A Humidifier?
- R
  Robert SalazarAug 29, 2025
  If the patient-side temperature displays as “--” and flashes in red, it signifies a malfunction of the patient-side probe. Replace the temperature-humidity data cable to fix this.