Part number 46115-VUH (Solenoid Heater Control Valve) has been
replaced by part number 461171 (Servo Heater Control Valve). Please
see illustration below for installation and flow direction. See wiring
diagrams on Pages 3 and 4 of this insert for proper wiring connections.
NOTE:
A. Wiring harness modification is required to install this valve.
Follow the wiring harness modification instructions on
Pages 5 and 6 of this insert.
B. Flow direction follows molded arrow on valve.
C. Connection between heater control valve and wiring adapter
may be located in engine bay or passenger compartment. Be
sure to secure ground ring terminal to chassis ground.
ATTENTION:
From Intake
Manifold
From Heater Core
To Water Pump
From Heater
Control Valve
to Heater Core
Heater
Hose
Instructions, notices and wiring diagrams included in this
insert supersede those included in main instruction booklet.
Hose Clamps
Wiring Adapter
Ground
Ring
Terminal
907173 REV A 5/14/14, PG 1 OF 6
To Next Page
Need help?
General