13
Contents
Previous
Page
First
Page
Next
Page
Previous
View
10 The camera mounting plate (7) is a sliding fit in the head, adjustable fore and aft by 50 mm from its
central position. A slide clamp, operated by a rotary lever (10), is located on the right-hand side of the head for
adjustment of the plate position. A slide release (15) on the left-hand side of the head allows removal of the
camera and slide plate complete. To remove the slide plate, release the slide clamp and move the slide plate
fully rearwards. Operate the slide release by pushing it in and holding. With the release depressed, the end
stop which limits the rearward movement of the slide plate is disengaged, and the plate can be slid bodily from
the head. This feature is an aid to rapid camera set-up.
11 A Vinten "Quickfit" adaptor (1) may be fitted to the slide plate. This optional extra enables any camera
fitted with a "Quickfit" wedge to be rapidly fitted to or removed from the head.
12 Attachment points for the pan bar (11) are located at the rear of the head, on either side of the camera
mounting platform. A telescopic pan bar is supplied and is fitted using a pan bar clamp, with angular
adjustment available on the mount serrations. A second pan bar may be fitted.
To Next Page
Loading...