35
Contents
Previous
Page
First
Page
Next
Page
Previous
View
14.47 Apply Loctite 222E to the threads of one screw (20) and secure thrust washer (18) to pan drag
actuator adaptor (36).
14.48 Apply Loctite 222E to the threads of pan shaft screw (22) and install in the pan axis spigot of
mechanism housing (6). Tighten screw to a torque of 2.26 Nm (20 lbfin.), slacken off and retighten to a
torque of 1.36 Nm (15 lbfin.).
14.49 Turn the spherical base in both directions relative to the mechanical housing and confirm that the
movement is smooth and quiet.
14.50 If dismantled, degrease threads of spherical base stud (24) and spherical base stud carrier (23)
and assemble using Loctite 601. Allow Loctite to cure.
14.51 Degrease face of boss and three threaded holes in the boss of spherical base (19), face of
spherical base stud carrier (24).
14.52 Apply blue Hylomar gasket sealant to face of spherical base stud carrier (24) and assemble to
spherical base, ensuring that the cylindrical location pip engages in the 4.0 mm dia plain hole.
14.53 Apply Loctite 222E to the threads of three screws (20) and secure spherical base stud carrier
(24) to spherical base (19).
14.54 Degrease the cross hole in the end of pan drag knob shaft (4) and dowel pin (5).
14.55 Secure dowel pin (5) symmetrically in the cross hole of pan drag knob shaft (4) using Loctite 638
and allow to cure.
14.56 Apply 240G grease to the threads of the pan drag knob shaft (4) and the dowel pin in the shaft
and install pan drag shaft in the mechanism housing (6) so that the dowel pin engages in the notches in
the bell crank (2) and the threaded portion projects into the boss for the pan drag knob
14.57 Referring to Fig 6.6, install the pan drag knob components as follows:
14.57.1 If removed, install Spirol pin (10) in the face of pan drag knob boss of mechanism
housing and drive it in to leave about 11 mm projecting from the face.
14.57.2 Assemble drag detent ring (7) onto grommet (8), with textured side outwards.
14.57.3 Install grommet (8), complete with detent ring (7), on the drag knob boss of the
mechanism housing, engaging the location notch on Spirol pin (10), and push it fully home
against the face of the boss. Lubricate detent arms on outside of detent ring (7) with white
bearing grease.
14.57.4 Holding the pan drag knob shaft in position in the mechanism housing, assemble one
shim washer (5), eight disc springs (6) and a second shim washer (5) onto the pan drag knob
actuator shaft (9). Ensure that the first four disc springs are assembled with the concave face
towards the mechanism housing and the last four are assembled with the concave face
outwards, as shown in Fig 6.6.
14.57.5 Screw the drag knob boss (4) onto the pan drag knob actuator shaft (9) to take up the
clearances, but do not tighten any further.
14.57.6 Degrease screw (2) and threaded bore of drag knob boss (4).
To Next Page
Loading...