Before the appliance is used, it must be properly positioned and
installed as
described in this manual, so read the manual carefully. To reduce the
risk of fire,
electrical shock or injury when using the appliance, follow basic
precautions,
including the following:
•Plug into a grounded 3-prong outlet, do not remove grounding prong, do not use an
adapter, and do not use an extension cord
• Replace all panels before operating
• It is recommended that a separate circuit, serving only your appliance, be provided. Use
receptacles that cannot be turned off by a switch or pull chain
• Never clean appliance parts with flammable fluids. These fumes can create a fire hazard
or explosion. And do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance. The fumes can create a fire hazard or
explosion.
• Before proceeding with cleaning and maintenance operations, make sure the power line
of the unit is disconnected.
• Do not connect or disconnect the electric plug when your hands are wet
• Unplug the appliance or disconnect the power before cleaning or servicing. Failure to do
so can result in electrical shock or death.
• Do not attempt to repair or replace any part of your appliance unless it is specifically
recommended in this material. All other servicing should be referred to a qualified
technician.
• Use two or more people to move and install the appliance. Failure to do so can result in
back or other injury.
• To ensure proper ventilation for your appliance, the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 55
0
F (13
0
C) and
below 90
0
F (32
0
C). This unit must be installed in an area protected from the elements,
such as wind, rain, water spray or sunlight.
• The appliance should not be located next to ovens, grills or other sources of high heat.
• The appliance must be installed with all electrical, water and drain connections in
accordance with state and local codes. A standard electrical supply (115 V AC only, 60
Hz), properly grounded in accordance with the National Electrical Code and local codes
and ordinances is required.
• Do not kink or pinch the power supply cord of the appliance.
• The fuse (or circuit breaker) size should be 15 amperes.
• It is important for the appliance to be leveled to work properly. You may need to make
several adjustments to level it.
• All installation must be in accordance with local plumbing code requirements.
• Make certain that the pipes are not pinched or kinked or damaged during installation.
• Check for leaks after connection.
• Never allow children to operate, play with or crawl inside the appliance
• Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners
may damage or discolor the interior.
• Do not use this apparatus for other than its intended purpose.
To Next Page
Loading...