Manual VIPA System 200V Chapter 3 Deployment IM 253DP
HB97E - IM - RE_253-xDPxx - Rev. 12/44 3-21
IM 253-xDPx1 - DP-V1 slave - Project engineering
The module is configured by means of your PROFIBUS master
configuration tool. During the configuration you will assign the PROFIBUS
slave modules to your master module.
The direct allocation is defined by means of the PROFIBUS address that
you have to set at the slave module.
The Slaves are projected via gsd-file at the hardware configuration.
Each PROFIBUS module is delivered with a floppy disk by vipa. The floppy
disc contains all GSD- and type files of the PROFIBUS modules from VIPA
as Cx000023_Vxxx.ZIP file. The assignment of the GSD-file to your slave is
shown in the "Readme.txt" file of Cx000023_Vxxx.ZIP.
Please install the required files from your floppy disc into your configuration
tool. Details on the installation of the GSD and/or type files are available
from the manual supplied with your configuration tool.
You may also download the GSD file via the Service area www.vipa.com >
Service > Downloads > PROFIBUS GSD files.
After the installation of the GSD-file you will find e.g. the DP-V1 slave in the
hardware catalog from Siemens at:
PROFIBUS DP>Additional field devices>I/O>VIPA_System_200V>
VIPA 253-1DP01
Note!
Please use the appropriate GSD for DP-V0 for PROFIBUS DP master
which do not support DP-V1.
The project engineering of the IM 253DP slave at the IM 208 DP master
from VIPA is to be find in the description to the DP master.
General
GSD- file
Deployment at a
IM 208DP master
from VIPA
To Next Page
Loading...
