Manual VIPA System SLIO Chapter 1 Basics and Assembly
HB300E - PS-CM - Rev. 11/28 1-7
Installation
There is a locking lever at the top side of the terminal module. For mounting
and demounting this locking lever is to be turned upwards until this
engages audible.
Now the module may be pulled forward.
For mounting plug the module to the module installed before and push the
module to the mounting rail guided by the strips at the upper and lower side
of the module.
The module is fixed to the mounting rail by pushing downward the locking
lever.
The modules may either separately be mounted to the mounting rail or as
block. Here is to be considered that each locking lever is opened.
Clack
1 2 3
For the exchange of a electronic module, the electronic module may be
pulled forward after pressing the unlocking lever at the lower side of the
module.
For installation plug the electronic module guided by the strips at the lower
side until this engages audible to the terminal module.
1. Press
2. Pull
Clack
1 2 3
Functional
principle
To Next Page
Loading...
