Manual VIPA System SLIO Chapter 1 Basics and Assembly
HB300E - PS-CM - Rev. 11/28 1-11
• For mounting turn the locking lever of the module to be mounted
upwards.
• To mount the module put it to the gap between the both modules and
push it, guided by the stripes at both sides, to the mounting rail.
• Turn the locking lever downward again.
• Plug again the electronic module, which you have removed before.
4 5
6
Bus interface and power module of a head module may not be
separated! Here you may only exchange the electronic module!
•
Remove if exists the wiring of the head module. More about this may be
found at "Wiring".
• Press the unlocking lever at the lower side of the just mounted right
module and pull it forward.
• Turn all the locking lever of the head module to be exchanged upwards.
• Pull the head module forward.
1
2
Exchange of a head
module
(e.g. bus coupler)
To Next Page
Loading...
