Chapter 3 Clamp modules Manual VIPA System SLIO
3-4 HB300E - PS-CM - Rev. 11/28
VIPA 001-1BA10 - 8xDC 0V clamps
This clamp module is a "potential distributor module". The ground GND of
the DC 24V power section supply may be accessed by 8 clamp connectors
of the terminal.
The backplane bus is looped through the module. So this module has no
module ID, but influences the maximum number of modules to be
connected.
• 8 clamp connectors ground GND power section supply
• Clamp current max. 10A
• Backplane bus looped through
• Isolation 500Veff (field voltage to the bus)
1
2
3
4
[1]
[2]
[3]
[4]
Locking lever terminal module
Backplane bus
DC 24V power section supply
Terminal
Description
Properties
Structure
To Next Page
Loading...
