Chapter 3 Clamp modules Manual VIPA System SLIO
3-6 HB300E - PS-CM - Rev. 11/28
VIPA 001-1BA20 - 4xDC 24V and 4xDC 0V clamps
This clamp module is a "potential distributor module". The DC 24V
respectively ground GND of the power section supply may be accessed by
4 clamp connectors each of the terminal.
The backplane bus is looped through the module. So this module has no
module ID, but influences the maximum number of modules to be
connected.
• 4 clamp connectors DC 24V power section supply
• 4 clamp connectors ground GND power section supply.
• Clamp current max. 10A
• Backplane bus looped through
• Isolation 500Veff (field voltage to the bus)
1
2
3
4
[1]
[2]
[3]
[4]
Locking lever terminal module
Backplane bus
DC 24V power section supply
Terminal
Description
Properties
Structure
To Next Page
Loading...
