Manual BG41/BG42/BG43 Software
Rev. 99/49 4-5
K/0
K= Number of channels, through which the data should be transmitted.
The second byte must be 0. The channel number used is dependent upon the
interface:
Building block BG41 channel number 1
Building block BG42 channel number 1, 2
Building block BG43 channel number 1, 2, 3
BAUD
Different baud rates can be set by entering the respective codes. Optional baud
rates from 150 to 38400 baud can be set with the plug connector J11 on the
building block. To enable this, J11, which is inserted in its delivery state at a baud
rate of 75 to 19200 baud, must be reinserted.
ZEI
Character lengths for transmission. The length of characters can be from 5 to 8 bits.
PARI
Parity Setting:
left byte: 1 = even parity
0 = uneven parity
right byte 1 = with parity
0 = without parity
STOP
Setting the number of stop bits
Input Stop bits
1=1
2=11/2
3=2
To Next Page
Loading...
